Can you pour bleach down a well?
Mix the bleach with the well water. Then place the hose in the hole where you poured the bleach, allow the water to run back into the well for 15-20 minutes. Ⅰ Remove the hose and replace the well cap, plug, or vent.
How do you clean bacteria out of a well?
You can use regular household bleach to disinfect a well. The chlorine in the bleach will destroy bacteria. Check the label on the bottle to make sure the bleach does not have any kind of additives (ex: scent, detergent).
How much bleach should I put in my drilled well?
Dug well (1 meter/3 foot diameter) Add 1 litre (1 quart) of household bleach for every 1.5 metres (5 feet) of depth of water. If you don’t know how high the water stands, use the well casing depth to estimate how much household bleach to use.
How much chlorine is needed to disinfect a well?
CALCULATE AND POUR: Pour 3 pints of chlorine bleach per 100 gallons of water plus an additional 3 pints into your well as described above. MIX: Attach a clean garden hose to the outdoor faucet nearest the well and place the end of the hose inside the well.
Can I put a chlorine tablet in my well?
the well has been flooded or exposed to bacterial contamination in another manner, such as a crack in the well cap. Chlorine granules, tablets and liquid chlorine in the form of household bleach can all be used to disinfect your well.
How do you bleach a well water system?
Mix 2 quarts bleach in 10 gallons of water; pour into well. Connect a garden hose to a nearby faucet and wash down the inside of the well. Open each faucet and let the water run until a strong chlorine odor is detected, then turn it off and go to the next one. Don’t forget outdoor faucets and hydrants.
How do you shock a drilled well with bleach?
Scrub the well cap and the casing with a brush. Fill a clean bucket with 3 gallons water to shock a drilled well. Carefully pour 1/2 gallon of household bleach into the water. This will disinfect a well that measures 4 inches in diameter and is 100 feet deep or less.