How do I reset my scantronic 9651?
There are two levels of ‘reset’ on a Scantronic 9651 alarm – the ‘user reset’ and ‘engineer reset’. From a user reset perspective, to reset a Scantronic 9651 you need to do the following: Enter your 4 digit code (this will show the alarm cause) Re-enter your 4 digit code again- PRESS X.
How do I reset my scantronic alarm?
To reset your Scantronic 9651 / 9751 alarm after an activation, enter your 4 digit code. This will show the alarm cause. Having read the alarm cause (e.g. ‘zone 3’ activated), re-enter your 4 digit code again followed by ‘X’.
How do I change the code on scantronic 9651?
TO CHANGE MASTER CODE Key in the master user code, Press 4. change this) Enter the existing master user code and press tick. (the display will show UO1:User 1) press tick. Enter your new user code, which will be displayed, on screen.
How do you omit zone on scantronic 9651?
Press the number of the zone you want to omit (for example, press 07 to omit zone 7) and then press .
How do you reset your house alarm after a power cut?
How to reset a house alarm after a power cut?
- Locate the “System” or “System Status” button. On your home alarm keypad, find the “System” or “System Status” button.
- Open the control panel.
- Remove the backup battery.
- Switch the circuit breaker off and on.
- Replace the backup battery.
- Input your user code.
How do I reset my scantronic 9427 alarm?
If your Scantronic 9448 or 9427 alarm system has been activated, the zone light that was triggered will glow red on your alarm. In order to reset your alarm, simply enter your 4 digit code. Once this is done your alarm system will be ready.
How do I change the battery in my scantronic 9651?
How to change Scantronic 9651 alarm battery
- Remove cover of alarm panel (N.B. alarm will ring)
- Remove and replace alarm battery.
- Replace alarm panel cover and secure (making sure tamper spring is pressed down)
How do you turn off a house alarm without the code?
Locate the control panel of your main security system and turn it off. Locate the power source and disconnect the power. This is the quickest way to disarm a home alarm without the code. Remove the standby battery if it has one.
How do I reset my house alarm after tampering UK?
How to reset a house alarm after tamper?
- Remove the cover.
- Remove the battery.
- Press and hold the tamper button.
- Insert the battery while holding the tamper button. The LED light will flash. Hold the button until it stops flashing.
- Replace the cover.