How wide is a Dakota rear end?
The early ones will be a 8.25″ rear, later ones are a 9.25″. But, even the early ’87-’96 Daks have a 69.4″ track width, which is almost 14″ wider than the track on an A-body (55.6″).
What is the track width Dodge Dakota?
track width is 61 inches, if it is a pre 97 dakota, on the wide side for the early chevs, but it will fit.
What does axle WMS mean?
WMS. Wheel Mounting Surface: This is the surface on the axle that the wheel sits flat on. This is usually a drum brake drum, disc brake disc, or a wheel hub. You’ll often see this used in a “WMS to WMS” measurement, which is the same as “axle width”.
How wide is a Ford Explorer 8.8 rear end?
7] From the factory, 8.8s use 1330- or 1310-series U-joints. This is the companion flange where the yoke bolts. The 1330 has a 3316-inch width for the U-joint, and the 1310 has a 358-inch width. The 1330 is usually found in Ford trucks.
How do you find the gear ratio on a Dodge Dakota?
Write down the VIN number. The last 6 characters represent your Dakota’s unique serial number. Call your local dodge dealership or their main line at 800-423-6343. They will be able to give you the exact gear ratio based off the VIN number you have.
What is the wheelbase of a 2000 Dodge Dakota?
112 to 131″2000 Dodge Dakota / Wheelbase
What is wheelbase and track width?
wheel base (the distance between the front and the rear wheels) has to be larger than 200 mm and the track width (the distance between two wheels on the same axle) has to be larger than 160 mm.
What is WMS width?
WMS is the German Shoe Institute’s mark of quality for verified children’s shoes and the measuring of children’s feet, and stands for nothing more than „Weit“(wide), „Mittel“(medium) und „Schmal“(narrow). The three different widths correspond to children’s foot shapes.
How do you measure a rear end width?
Using a measuring tape, measure from one flange to the other. To ensure an accurate measurement, always measure from end to end where the wheels bolt on to the axle. Record the measurement.
How much power can a Ford 8.8 handle?
Dead stock (31 spline version, which is what the Explorer has) it can handle up to about 400 rwhp as long as you’re not on DR’s or Slicks.
How do I tell what gear ratio my Vin is?
The gear ratio is usually listed in the VIN code located on driver’s door, the glove box, or the ID plate on the dashboard. Count the times a rear wheel goes around for one driveshaft turn: if its 3 1/2 it’s a 3.50:1. Divide the number of teeth on the ring gear by the number of teeth on the pinion gear.