What is aviom in audio?
An Aviom input module takes your existing audio sources, converts them to digital and outputs the digital audio over a single Cat-5e cable using Aviom’s A-Net technology. A console card allows you to route audio from your digital mixing console in the digital domain directly to an Aviom A-Net output.
How do I ungroup a channel in aviom?
Muting a Channel: Select a channel by pressing a numbered channel button. Press the Mute button. Press Mute again to un-mute a channel.
How do I save aviom settings?
To save your mix on an A-16, A-16II, or A-16R/A-16CS, press and hold the RECALL and GROUP buttons (lower left corner) and then press one of the channel select buttons. On all Aviom Personal Mixers, the channel select buttons also serve as mix storage locations.
What does a personal mixer do?
The mixer unit can add reverb and delay, and features a four-band parametric EQ for each channel. An SD card slot allows for full multitrack recording of 16 individual channels, plus the stereo mix, at 24-bit/48kHz.
How do you set up a personal mixer?
Mixer setup instructions
- Turn each channel’s gain knob and level fader all the way down.
- Connect your main speakers to the mixer’s Main out jacks.
- Power on the mixer and speakers (or power amplifier).
- Set mixer levels to unity and adjust the speaker output level.
- Turn up the Main mix fader level to 0 (unity).
What’s a monitor mix?
A mix created to allow musicians to hear themselves, whether onstage or in the studio. Depending on the situation and application, a monitor mix may also be known as foldback, a cue mix, a headphone mix, or other names.
How do I set up a separate monitor mixer?
To create a monitor mix, start by turning up one of the Aux sends on a channel strip. That sends the channel to an Aux Master, which is then sent to an output of the mixer and the stage monitor connected to the respective Aux output jack. You then need to balance the aux send levels to complement the performer’s needs.
How do I connect my monitor speakers to my mixer?
How to Connect Stage Monitors
- Plug in a cable into the AUX outputs on the sound mixer. Typically the AUX jacks require quarter-inch plugs.
- Insert the other end of the cable into the amplifier. Skip this step if you use powered speakers.
- Run a line from the amplifier to the speaker.
- Run amplifier and speaker tests.
What is monitor out on mixer?
Monitor out is output to your monitor system. It helps you to adjust the level of the audio that goes into your monitors. Monitor outputs are usually found in audio devices such as audio interfaces, AV receivers, and mixer boards.
How do you mix a monitor?
What does a monitor engineer do?
A monitor engineer mixes the sound the musicians listen to onstage during a performance. Typically the musicians will be provided an individual mix with either speaker monitors (also called wedges) or in-ear monitor systems (IEMS).