How do you mirror a Zpool?

To create a mirrored storage pool, you use the zpool create command followed by the pool name, the mirror keyword, and the storage devices that will compose the mirror. Multiple mirrors can be specified by repeating the mirror keyword on the command line.

How do I replace a Zpool mirror?

The following are the basic steps for replacing a disk:

  1. Offline the disk, if necessary, with the zpool offline command.
  2. Remove the disk to be replaced.
  3. Insert the replacement disk.
  4. Run the zpool replace command. For example: # zpool replace tank c1t1d0.
  5. Bring the disk online with the zpool online command.

How do I replace Zpool?

To replace a device, use the “zpool replace” command followed by the pool name and the device name. If you are physically replacing a device with another device in the same location in a redundant pool, you need to identify only the replaced device. ZFS recognizes that it is a different disk in the same location.

How do you remove a disk from a Zpool mirror?

To remove devices from a pool, use the zpool remove command. This command supports removing hot spares, cache, log, and top level virtual data devices. You can remove devices by referring to their identifiers, such as mirror-1 in Example 3, Adding Disks to a Mirrored ZFS Configuration.

What is a ZFS mirror?

ZFS allows you to integrate many disks into a “zpool” for storage. There are many different configurations one could setup, but I’ll just focus on a simple ZFS mirror, where I have two disks, each of which will contain the same data, hence the name ‘mirror’.

What is Zpool Resilver?

A zpool resilver is an operation to rebuild parity across a pool due to either a degraded device (for instance, a disk may temporarily disappear and need to ‘catch up’) or a newly replaced device. In other words, moving the data from one device (the degraded/old disk) to a new device.

What is Vdev in ZFS?

vdev. Each zpool consists of one or more vdevs (short for virtual device). Each vdev, in turn, consists of one or more real devices . Most vdevs are used for plain storage, but several special support classes of vdev exist as well—including CACHE , LOG , and SPECIAL.

How do I unmount in ZFS?

You can unmount ZFS file systems by using the zfs unmount subcommand. The unmount command can take either the mount point or the file system name as an argument. The unmount command fails if the file system is busy. To forcibly unmount a file system, you can use the -f option.

What is a Zpool?

ZFS pool (Zpool) is a collection of one or more virtual devices, referred to as vdevs that appear as a single storage device accessible to the file system. The Zpool is the highest container in the whole ZFS system.

Is ZFS slow?

Many people found a problem on their ZFS system. The speed is slow! It is slow to read or write files to the system. In this article, I am going to show you some tips on improving the speed of your ZFS file system.

Categories: Other